支持 TouchLink® Pro 触摸屏和 eBUS® 按键面板 支持行业安全标准的通信协议 支持 LinkLicense® 6 个支持软件握手的双向 RS-232 串行端口 2 个支持硬件和软件握手的双向 RS-232 RS-422 RS-485 串行端口
Extron IPCP Pro 550 是一款通用的高性能控制处理器，设计在较大型应用环境中进行集中式视音频控制。作为 IP Link® Pro 系列的组成部分，IPCP Pro 550 采用安全标准和千兆以太网，确保了在标准网络架构上与多个 TouchLink® Pro 触摸屏兼容。它还支持 Extron LinkLicens®，进一步增强了 Extron Pro 系列控制系统的功能。IPCP Pro 550 是控制一个视音频系统内的多个设备和多种控制信号类型的理想之选。
特性
支持 TouchLink® Pro 触摸屏和 eBUS® 按键面板
支持行业安全标准的通信协议
支持 LinkLicense®
6 个支持软件握手的双向 RS-232 串行端口
2 个支持硬件和软件握手的双向 RS-232/RS-422/RS-485 串行端口
8 个红外/串行端口，用于外部设备的单向控制
4 个 Flex 输入/输出端口
8 个继电器，用于控制房间功能
eBUS 端口用于连接 eBUS 按键面板和附件
4 路可独立开关的 12 VDC 电源输出
以太网监视和控制
支持常见的 BMS（建筑管理系统）协议，如 BACnet、KNX 和 DALI
| IPCP Pro 550 | |
| Memory | |
|---|---|
| | 512 MB |
| | 4.5 GB |
| Software and control options | |
| | Extron Global Configurator® Plus and Professional for Windows®, Global Scripter® |
| | GlobalViewer®, Extron Control for iPad and Web, TouchLink® Pro touchpanels, or eBUS® button panels |
| Ethernet control | |
| | 1 |
| | 1 female RJ-45 connector |
| | 10/100/1000Base-T, half/full duplex with autodetect |
| | DHCP, DNS, HTTP, HTTPS, ICMP, NTP, SFTP, SMTP, SNMP, SSH, TCP/IP, UDP/IP |
| | Link speed and duplex level = autodetected IP address = 192.168.254.250 Subnet mask = 255.255.255.0 Gateway = 0.0.0.0 DHCP = off DNS: 127.0.0.1 |
| Serial control | |
| | 2 bidirectional RS-232, RS-422, RS-485 (ports 7 and 8) 6 bidirectional RS-232 (ports 1 through 6) |
| | (2) 3.5 mm captive screw connectors, 5 pole (6) 3.5 mm captive screw connectors, 3 pole |
| | 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits; 1 (default) or 2 stop bits; no parity (default), even, or odd parity |
| NOTE The 5-pole ports support both hardware and software flow control.The 3-pole ports support software flow control.The default for both types of ports is no flow control. | |
| | |
| Serial, 5-pole captive screw | |
| | Pin 1 = Tx, 2 = Rx, 3 = Gnd, 4 = RTS, 5 = CTS |
| | Pin 1 = Tx-, 2 = Rx-, 3 = Gnd, 4 = Tx+, 5 = Rx+ |
| | Pins 1 and 2 (tied together) = data-, 3 = Gnd, 4 and 5 (tied together) = data+ |
| | Pin 1 = Tx, 2 = Rx, 3 = Gnd |
| Flex I/O control | |
| | 4 analog input or digital input/output (configurable) |
| | (1) 3.5 mm captive screw connector, 5 pole |
| | |
| | 0 to 24 VDC, clamped at +30 VDC |
| | 29k ohms |
| | 1k ohms to +5 VDC |
| | Programmable range: 100 mV to 24 VDC, default = 2.4 VDC |
| | Programmable range: 100 mV to 24 VDC, default = 0.8 VDC |
| | 250 mA sink from 24 VDC max. |
| | 12 bit A/D, 0 to 24 VDC |
| | 1, 2, 3, 4 = flex I/Os 1, 2, 3, 4; 5 = Gnd |
| IR/serial control | |
| | 8 programmable: unidirectional RS-232 (±5 V), or TTL level (0 to 5 V) infrared (carrier and non-carrier) up to 300 kHz |
| | (4) 3.5 mm captive screw connectors, 4-pole |
| | 300 to 115200 baud (9600 baud = default); 8 (default) or 7 data bits; 1 (default) or 2 stop bits; no parity (default), even, or odd parity |
| | For each port, pin 1 = signal, 2 = Gnd |
| | 30 kHz to 300 kHz |
| | 30 kHz to 300 kHz |
| | 2" (5.1 cm) to 12" (30.5 cm) from the front panel |
| Relay control | |
| | 8 normally open relays |
| | (4) 3.5 mm captive screw connectors, 4 pole |
| | 24 VDC, 1 A |
| eBUS control | |
| | (1) 3.5 mm captive screw connector, 5 pole (uses 4 poles) |
| | +V = +12 VDC; +S = + signal; -S = - signal; G = ground |
| | Extron STP20-2/1000 or STP20-2P/1000 cable |
| | 1000 feet (305 meters) sum total for the eBUS system, regardless of topology. Power injection may be required depending on system cabling topology and primary power supply wattage. See the eBUS Technology Reference Guide for details. |
| | 12 watts |
| Switched DC power output | |
| | 4 switched 12 VDC outputs |
| | (4) 3.5 mm captive screw connectors, 2 pole |
| | Maximum 40 watts total |
| | |
| | 0.1 watt to 40 watts |
| General | |
| | Internal Input: 100-240 VAC, 50-60 Hz |
| | 61.8 watts |
| | Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing |
| | Convection, no vents |
| | 33.3 BTU/hr |
| | |
| | Yes, with optional 1U rack shelf |
| | Metal |
| | 1.7" H x 8.7" W x 10.5" D (1U high, half rack wide) (4.3 cm H x 22.1 cm W x 26.7 cm D) (Depth excludes connectors.) |
| | 2.5 lbs (1.1 kg) |
| | ISTA 1A in carton (International Safe Transit Association) |
| Regulatory compliance | |
| | CE, c-UL, UL UL Listed for use in plenum air handling spaces |
| | CE, C-Tick, FCC Class A, ICES, VCCI |
| | Complies with the appropriate requirements of RoHS, WEEE |
| | 3 years parts and labor |
| | 7 years parts and labor |
| NOTE All nominal levels are at ±10%. | |
| NOTE Specifications are subject to change without notice. | |
